极速赛车计划网

The StylAir regenerative desiccant dryer is a fully automatic unit designed to dry compressed air or gas to meet or exceed the customer's requirements. The dryer consists of dual drying chambers which are alternately cycled through drying and regeneration cycles. One chamber is drying air at all times.

The wet, compressed process air flows through one drying tower where water vapor is adsorbed into the desiccant - an inert, hygroscopic material with an enormous surface to mass ratio. The off-stream drying tower is regenerated by taking a small amount of the dried process air (purge) and passing it through its bed at low (atmospheric) pressure. The moisture trapped in the desiccant is released and is carried off by the purge flow and exhausted to atmosphere.

Back to SHL Overview...

Conservative Tower Sizing - Designed for Optimum Performance and Long Desiccant Life

  • Low upflow velocities - < 60 fpm
  • Long contact times - 5 sec. or more
  • Controlled blowdown and repressurization

Rugged, Reliable Industrial Controls

  • UL components from controllers to terminal boards to provide that extra measure of safety
  • High style NEMA 4/IP65 enclosures
  • Microprocessor/PLC based controls provide real diagnostic info

Standard corrosion resistant acrylic coating protects for years in adverse environments

ASME code designed and stamped drying towers on all floor models

SS Desiccant Support/Flow Distributors

  • Practically indestructible wedge-wire design prevents collapse or tearing; are cleanable and reusable (floor models)
  • High strength welded screen on wall models

Proven high reliability valving

  • Designed for air dryer service
  • Non-lubricated, high cycle design
  • Easy maintenance
  • Only dry, filtered pilot air is used for actuated valves

Separate desiccant fill and drain ports on all models (exc. SHL-H01N and SHL-H03N)

澳洲5历史走势图 澳洲幸运5开奖记录网 澳洲10官方下载